Share a caseSign in
EmissionsSeverity Low: usually safe to drive

P0141O2 Sensor Heater Circuit (bank 1 sensor 2)

What it means

The heater inside the oxygen sensor bank 1 sensor 2 is not drawing the expected current. Without it the sensor takes longer to work after a cold start. The downstream sensor (after the catalyst) is mainly used to check how well the catalyst works.

Symptoms

  • Check engine light
  • Usually no change in how the car drives
  • Catalyst monitor may not complete

Common causes

  • Open heater element inside the sensor
  • Blown fuse or open heater supply
  • Open ground or ECU heater control circuit
  • Corroded connector

What to check first

  1. Measure the heater resistance (typically 3–15 Ω, check the specification)
  2. Check the 12 V supply with the key on
  3. Check the heater control (ground) side from the ECU
Can I drive with P0141? Usually yes. P0141 rarely affects how the car drives, but it keeps the check engine light on and can fail an emissions test.

Generic OBD-II meaning. Manufacturer-specific meanings and checks can differ; always check the service information for the car.

How to test the parts behind P0141

Oxygen (lambda) sensorWiring, typical values, multimeter and scope tests

Cases with P0141 (0)

Share yours

No published cases with this code yet.

Colleagues asking about P0141

Ask for help

Stuck on P0141? Describe what you measured and ask the community.

P0141: questions and answers

What does P0141 mean?

P0141: O2 Sensor Heater Circuit (bank 1 sensor 2). The heater inside the oxygen sensor bank 1 sensor 2 is not drawing the expected current. Without it the sensor takes longer to work after a cold start. The downstream sensor (after the catalyst) is mainly used to check how well the catalyst works.

What are the symptoms of P0141?

Check engine light. Usually no change in how the car drives. Catalyst monitor may not complete.

What causes P0141?

Open heater element inside the sensor. Blown fuse or open heater supply. Open ground or ECU heater control circuit. Corroded connector.

How do you diagnose P0141?

1. Measure the heater resistance (typically 3–15 Ω, check the specification) 2. Check the 12 V supply with the key on 3. Check the heater control (ground) side from the ECU

Can I drive with P0141?

Usually yes. P0141 rarely affects how the car drives, but it keeps the check engine light on and can fail an emissions test.