Share a caseSign in
Air intakeSeverity High: diagnose before driving on

P0222Throttle/Pedal Position Sensor/Switch "B" Circuit Low

What it means

The throttle or pedal position sensor signal voltage is lower than the sensor can normally produce (usually below about 0.2 V on a 0–5 V sensor). Most often the signal wire is shorted to ground or the 5 V supply is missing.

Symptoms

  • Limp mode with very limited power
  • Hesitation, surging or erratic idle
  • Electronic throttle warning light

Common causes

  • Signal wire shorted to ground or chafed through
  • 5 V reference open, or pulled down by another faulty sensor on the same supply
  • Failed throttle or pedal position sensor
  • Water or corrosion in the connector

What to check first

  1. With the key on, measure the 5 V reference at the connector (about 4.8–5.1 V)
  2. Back-probe the signal and watch it while wiggling the harness
  3. Unplug sensors that share the 5 V reference one at a time and see whether the supply recovers
Can I drive with P0222? Not recommended. P0222 can lead to stalling, limp mode or engine damage; diagnose it before driving further.

Generic OBD-II meaning. Manufacturer-specific meanings and checks can differ; always check the service information for the car.

How to test the parts behind P0222

Throttle and accelerator pedal position sensorsWiring, typical values, multimeter and scope tests

Cases with P0222 (0)

Share yours

No published cases with this code yet.

Colleagues asking about P0222

Ask for help

Stuck on P0222? Describe what you measured and ask the community.

P0222: questions and answers

What does P0222 mean?

P0222: Throttle/Pedal Position Sensor/Switch "B" Circuit Low. The throttle or pedal position sensor signal voltage is lower than the sensor can normally produce (usually below about 0.2 V on a 0–5 V sensor). Most often the signal wire is shorted to ground or the 5 V supply is missing.

What are the symptoms of P0222?

Limp mode with very limited power. Hesitation, surging or erratic idle. Electronic throttle warning light.

What causes P0222?

Signal wire shorted to ground or chafed through. 5 V reference open, or pulled down by another faulty sensor on the same supply. Failed throttle or pedal position sensor. Water or corrosion in the connector.

How do you diagnose P0222?

1. With the key on, measure the 5 V reference at the connector (about 4.8–5.1 V) 2. Back-probe the signal and watch it while wiggling the harness 3. Unplug sensors that share the 5 V reference one at a time and see whether the supply recovers

Can I drive with P0222?

Not recommended. P0222 can lead to stalling, limp mode or engine damage; diagnose it before driving further.