Share a caseSign in
Air intakeSeverity High: diagnose before driving on

P2127Throttle/Pedal Position Sensor/Switch "E" Circuit Low

What it means

The accelerator pedal position sensor signal voltage is lower than the sensor can normally produce (usually below about 0.2 V on a 0–5 V sensor). Most often the signal wire is shorted to ground or the 5 V supply is missing.

Symptoms

  • Limp mode or no response to the pedal
  • Engine stays at a fixed rpm
  • Electronic throttle warning light

Common causes

  • Signal wire shorted to ground or chafed through
  • 5 V reference open, or pulled down by another faulty sensor on the same supply
  • Failed accelerator pedal position sensor
  • Water or corrosion in the connector

What to check first

  1. With the key on, measure the 5 V reference at the connector (about 4.8–5.1 V)
  2. Back-probe the signal and watch it while wiggling the harness
  3. Unplug sensors that share the 5 V reference one at a time and see whether the supply recovers
Can I drive with P2127? Not recommended. P2127 can lead to stalling, limp mode or engine damage; diagnose it before driving further.

Generic OBD-II meaning. Manufacturer-specific meanings and checks can differ; always check the service information for the car.

Cases with P2127 (0)

Share yours

No published cases with this code yet.

Colleagues asking about P2127

Ask for help

Stuck on P2127? Describe what you measured and ask the community.

P2127: questions and answers

What does P2127 mean?

P2127: Throttle/Pedal Position Sensor/Switch "E" Circuit Low. The accelerator pedal position sensor signal voltage is lower than the sensor can normally produce (usually below about 0.2 V on a 0–5 V sensor). Most often the signal wire is shorted to ground or the 5 V supply is missing.

What are the symptoms of P2127?

Limp mode or no response to the pedal. Engine stays at a fixed rpm. Electronic throttle warning light.

What causes P2127?

Signal wire shorted to ground or chafed through. 5 V reference open, or pulled down by another faulty sensor on the same supply. Failed accelerator pedal position sensor. Water or corrosion in the connector.

How do you diagnose P2127?

1. With the key on, measure the 5 V reference at the connector (about 4.8–5.1 V) 2. Back-probe the signal and watch it while wiggling the harness 3. Unplug sensors that share the 5 V reference one at a time and see whether the supply recovers

Can I drive with P2127?

Not recommended. P2127 can lead to stalling, limp mode or engine damage; diagnose it before driving further.