Share a caseSign in
Air intakeSeverity High: diagnose before driving on

P2128Throttle/Pedal Position Sensor/Switch "E" Circuit High

What it means

The accelerator pedal position sensor signal voltage is higher than the sensor can normally produce (close to 5 V). Most often the signal wire or the sensor ground is open, or the signal is shorted to a supply voltage.

Symptoms

  • Limp mode or no response to the pedal
  • Engine stays at a fixed rpm
  • Electronic throttle warning light

Common causes

  • Open signal wire (the ECU's pull-up then reads high)
  • Open or high-resistance sensor ground
  • Signal shorted to the 5 V reference or to battery voltage
  • Failed accelerator pedal position sensor

What to check first

  1. Measure the voltage drop on the sensor ground with the key on (should be under 0.1 V)
  2. Unplug the sensor: the live data should jump to the opposite extreme
  3. Inspect the harness for chafing against other wires or hot parts
Can I drive with P2128? Not recommended. P2128 can lead to stalling, limp mode or engine damage; diagnose it before driving further.

Generic OBD-II meaning. Manufacturer-specific meanings and checks can differ; always check the service information for the car.

Cases with P2128 (0)

Share yours

No published cases with this code yet.

Colleagues asking about P2128

Ask for help

Stuck on P2128? Describe what you measured and ask the community.

P2128: questions and answers

What does P2128 mean?

P2128: Throttle/Pedal Position Sensor/Switch "E" Circuit High. The accelerator pedal position sensor signal voltage is higher than the sensor can normally produce (close to 5 V). Most often the signal wire or the sensor ground is open, or the signal is shorted to a supply voltage.

What are the symptoms of P2128?

Limp mode or no response to the pedal. Engine stays at a fixed rpm. Electronic throttle warning light.

What causes P2128?

Open signal wire (the ECU's pull-up then reads high). Open or high-resistance sensor ground. Signal shorted to the 5 V reference or to battery voltage. Failed accelerator pedal position sensor.

How do you diagnose P2128?

1. Measure the voltage drop on the sensor ground with the key on (should be under 0.1 V) 2. Unplug the sensor: the live data should jump to the opposite extreme 3. Inspect the harness for chafing against other wires or hot parts

Can I drive with P2128?

Not recommended. P2128 can lead to stalling, limp mode or engine damage; diagnose it before driving further.